How to Unclog a Toilet

Amazing! How to Unclog a Toilet

Information about How to Unclog a Toilet

Phil Puccio

Unclog the toilet

As the old saying goes – there is more than one way to clean a toilet. OK, we just made that up, but we’re here to prove it’s true. Sure we love our piston, but what if you don’t have one? Have you tried soap or baking soda?

Follow our detailed instructions on how to remove a clog from a toilet with a plunger, but stick with plunger-free toilet clog hacks as well. Either way, we will free your toilet from blockages and continue to operate as usual.

How to submerge a toilet

Flange tappet

The best way to clean a toilet is to learn to use a flanged piston properly. Flange tappet are specially designed for lowerable toilets. The “flange” is an elongated, sleeve-like rubber flap that is built into the underside of the rubber cap of the piston. Insert this flange directly into the toilet bowl’s drain hole for a tighter seal than a traditional cup piston.

1. Prepare the area around the toilet

Immersion can get messy. Put on rubber gloves and lay out towels or plastic wrap to catch spills.

2. Equalize the amount of water in the bowl

To maximize the effectiveness of immersion, it is advisable to approximately fill the toilet bowl half full of water (enough so that you can completely submerge the flask cup).

3. Place the flange in the toilet drain

Maneuver the flange until it fits snugly into the toilet bowl drain. Insert the flange at an angle so that the flap fills with water when it is lowered.

A flask cup sits neatly over a toilet drain.

4. Place the cup over the drain

Place the flask’s cup tightly over the drain while leaving the flange tucked in. When making the seal, drain water from the bowl under the cup. The water between the cup and the drain helps create suction pressure to clear clogs.

5. Position and “test” your piston seal

If you have created a seal with both the flange and the cup, “test” it before you begin. Push the plunger straight down and then pull it back up like you normally would to clear the clog, but do so slowly. Make sure the gasket stays in place throughout the process.

5a. (Optional) Apply petroleum jelly around the flask’s cup

If you have trouble maintaining a seal, Try applying petroleum jelly to the cup. Vaseline will keep the cup from sliding off the bottom of the bowl.

6. Immerse vigorously 5 to 6 times

Firmly push down on the plunger to force the cup down and drive the flange down the drain, then pull the cup back up to “reset”. Repeat this movement repeatedly and steadily, but not too forcefully or quickly. for 20 seconds.

7. Check the water level in the toilet bowl

After thirty seconds of immersion, quickly break the seal and remove the plunger. Listen for a gurgling sound from the drain (a good sign) and check the water level in the toilet bowl. If almost all of the water in the bowl has drained, you have probably cleared the clog.

7a. (Optional) Repeat dipping as needed

If the water in the toilet bowl has not drained, repeat the immersion process a few more times. Add water as needed or drain until your bowl is half full before starting again.

8. Test to see if the blockage is gone

Before testing your flush, remove the tank cap. Squeeze the handle as normal and watch the toilet bowl closely. If you haven’t cleared the blockage, the toilet won’t flush and the bowl will begin to fill with water. Prevent overflow by manually closing the toilet door.

We recommend that you only repeat the immersion up to five times. Immersion for too long can damage your toilet, and some clogs are too persistent for even the most effective plumbing.

How to free a plungerless toilet

Worst-case scenario: you only have one toilet in your house, it’s clogged, you don’t have a plunger, and you have a dinner party in two hours. Stay calm. We still have a few more diamonds from Mike to help flush the toilet again.

A bottle of washing-up liquid

How to unclog a toilet with dish soap

Dish soap has natural properties that break down grease and dirt in solids. It can also act as a lubricant to get things moving.

Simply squirt a generous cup of your favorite soap down your toilet drain. Follow the soap with a bucket of hot (not boiling) water. Water that is too hot can crack the porcelain. Wait 30 minutes and check. Repeat if necessary.

A box of baking powder

How to free a toilet with baking soda

Sprinkle a cup of baking soda around your toilet’s drain. Slowly add two cups of white vinegar. Allow an hour for the chemical reaction to hit the constipation and work its magic. You can use a bucket of hot water as mentioned above. Repeat the process if necessary.

How to clean a toilet with poop in it

A bottle of cola.

Yes, we said it, but it is. Sometimes after your uncle has been in your bathroom most of the morning, you end up with a very uncomfortable constipation.

The secret here is Coca Cola. Not for your uncle, for your toilet. It turns out that coke has some great acids in it that also double as decalcifying agents. The carbonic acid also helps by putting pressure on the constipation.

Pour a can or ½ liter bottle of Cola into your toilet, then quickly cover the bowl with plastic wrap. This will help keep the pressure going. After one hour there should be enough dissolution to allow normal irrigation.

Properly cleaning up the toilets in Los Angeles

If you are dealing with a stubborn constipation that won’t move, then call Mike Diamond. Our experienced plumbers have yet to encounter a blockage that they could not clear.

Breaking Story – How to Unclog a Toilet

The Latest News on How to Unclog a Toilet

Original Source: https://mikediamondservices.com/blog/unclogging-toilets/
Category – Plumbing

© 2022 welcometoabode.com - WordPress Theme by WPEnjoy